BMW 3 series E46

1 Lower glass completely downwards.
2 Remove door facing, uncover in the right part above, address to corresponding section.

It is not necessary to remove a lateral pillow of safety.

3 Take out a small screw-driver two clips-2 covers-1 from a forward end face of a door.

4 Uncover-1, thus begin from below. Take out a cover at the door terminator.

5 Take out a cover above from a flat clip (poses. And on an illustration) also wring out so that to provide upwards access to screws of fastening of a mirror.

6 Rasstykujte a socket of protection against a jamming glass (it white / a black cable).

7 Turn away screws of fastening-2 sound signals of a high-pitch tone-1 and remove it.

8 Rasstykujte a socket of a mirror of an exterior.
9 Keeping a mirror outside, turn out the screw-3.
10 Remove a mirror, thus pass through a door electric wires.

11 Establish a mirror, thus pass through a door electric wires.
12 Keeping a mirror outside, fix its screw-3.
13 Fix a sound signal of a high-pitch tone. Tighten screws-2 and-3 moment 6 Nm.
14 Join a socket of a mirror of an exterior and protection against a jamming glass.
15 Press protection against a jamming into a clip - And-.
16 Insert a cover of protection against a jamming on the terminator of a door and fix two clips at a door end face.
17 Establish door facing, address to corresponding section.