BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ Manual transmission and transmission a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   The general information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a forward bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a back bumper
      Removal and installation of the back shock-absorber
      Removal and cover installation обтекателя
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and installation of a cover of a luggage carrier
      Adjustment of a cover of a luggage carrier
      Removal and installation of the lock/cylinder of the lock of a cover of a luggage carrier
      Removal and installation газонаполненного an emphasis of a cowl/cover of a luggage carrier
      Replacement moldingов and model emblems
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation electric windows
      Removal and electric motor installation windows
      Removal and installation of a mirror of an external kind / a sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ Electric equipment schemes



Removal and installation of the cylinder of the lock

 REMOVAL

1 Uncover at a door end face.

The cover consists of two parts. At first take out the central part-1 screw-driver, then disconnect and take out an external part-2.

2 Turn out through an aperture in sheet of a door the screw-2 face key on 5 mm. Thus the screw press inside that it has not fallen.

3 Pull a cover-3-s the cylinder of the lock-4 a little back and release it, then pull outside. The screw is protected from falling by a corresponding nut.

4 Cautiously take out фиксаторный a hook-5 and uncover-3 the cylinder of the lock-4.

The second clamp is on an opposite side and on an illustration is not shown.


 INSTALLATION

5 Check up presence of damages on фиксаторном a hook of a cover of the cylinder of the lock, if necessary a cover replace.
6 Put on the cylinder of the lock a cover and fix it.
7 Turn away a lock nut of the screw with internal hexahedronом if it was fixed.
8 Insert the cylinder of the lock with a cover into a door aperture. Thus the cylinder pin should enter into the lock. If necessary insert a key into the cylinder of the lock and turn a pin a little.
9 Press the cylinder to a door and a little to a loop of a door and fix.
10 Wrap the screw with internal hexahedronом.

Do not tighten the screw too strongly, differently the lock cylinder can jam.

11 Insert a cover from outside a door end face. Press into an aperture at first an external part, then central.