BMW 3 series E46

Since 1998 of release

Repair and car operation

Removal, installation and window adjustment

To have possibility of moving of a window of a door at the removed lateral pillow of safety, it is necessary to disconnect quickly a negative cable (-) the storage battery. Thereof in memory of malfunctions corresponding record is made. After work end it is recommended to clear memory thereby to provide normal work of a pillow of safety. Address to Section Diagnostics of malfunctions. Work it is desirable to spend HUNDRED in conditions.

REMOVAL

1 Remove a lath of mine of glass-1. For this purpose protect a sticky tape-2 paint and varnish covering under a lath. Squeeze out a lath a plastic wedge-3 upwards from window mine. Thus, as is shown in an illustration, begin behind. In a forward part extend a lath under a mirror.

2 Remove facing of a door and uncover doors in a back part, address to corresponding section.

3 Open a window till the size And = 140 mm.

4 Turn out a bolt-1 back fastenings.

5 Turn out a bolt-2 forward fastenings.
6 Turn glass forward and take out from window mine.

INSTALLATION

7 Insert glass from above into mine of a window and fix at windows screws-1 and-2.
8 If the old window is established, check up ease of its course moving upwards and downwards. If necessary adjust.

ADJUSTMENT HAS FLOWN DOWN

9 Disconnect the back tyre windows-1. For this purpose loosen the fastening of nuts-2 and-3, without turning on them. Preliminary remove hermetic from a nut-3.

10 Move glass with стеклоподъемником completely upwards.
11 Tighten nuts-2 and-3.
12 Some times move glass upwards and downwards, having checked up ease of its course. If necessary repeat adjustment.
13 Establish into place facing, address to corresponding section.
14 Establish an external lath of mine windows. That the lath slid is better, it is recommended to grease with its soap solution, for example, means for ware washing. Insert a lath in front under a mirror, then gradually press below into mine.