BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ Manual transmission and transmission a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   The general information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a forward bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a back bumper
      Removal and installation of the back shock-absorber
      Removal and cover installation обтекателя
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and installation of a cover of a luggage carrier
      Adjustment of a cover of a luggage carrier
      Removal and installation of the lock/cylinder of the lock of a cover of a luggage carrier
      Removal and installation газонаполненного an emphasis of a cowl/cover of a luggage carrier
      Replacement moldingов and model emblems
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation electric windows
      Removal and electric motor installation windows
      Removal and installation of a mirror of an external kind / a sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ Electric equipment schemes



Removal and installation of the external handle of a door

 REMOVAL

1 Remove the lock cylinder, address to corresponding section.

2 Pull the handle of a door-1 outside and displace approximately on 2 mm back. Press the handle approximately on 4 mm inside and pull back.

Thus, the lock mechanism is fixed. If the door handle at removal lasts only back and is released, it is necessary to fix the lock mechanism manually, address to subsection "Installation".


 INSTALLATION

3 Check up directing-2 and a support-1, if necessary replace the handle.

4 If the door handle is replaced, remove consolidation of the handle and replace it.


 CHECK/ADJUSTMENT OF POSITION OF THE MECHANISM OF THE LOCK

For installation of the external handle of a door the lock mechanism is necessary for fixing. It means that the lever-4 is in position, as is shown in an illustration.

If the lever-4, as is shown in an illustration costs inside, the external handle of a door cannot be established. In this case the lock mechanism is necessary for establishing in assembly position, that is to fix.

 

5 Fix the lock mechanism: Enter a screw-driver-5 through an aperture-6 and press the lever-4 outside, pull a little back and fix.

6 Insert the handle with directing to an aperture.
7 Insert the handle with a reception part behind the lever-4 and press a door.
8 Displace the handle approximately on 4 mm forward, towards a loop, and fix.