The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
- Systems of cooling, heating
- System of cooling of the engine
Replacement of a cooling liquid
Thermoswitch check
Check of system of cooling under pressure
Connection and separation quick disconnect муфты
Removal and thermostat installation
Removal and installation of the fan / of a casing of the fan
Removal and installation of the fan with вязкостной муфтой
Removal and radiator installation
Removal and installation of the pump of a cooling liquid
+ Heater and the conditioner of air of salon
+ Power supply systems, injection and release
+ Engine electric equipment
+ Manual transmission and transmission a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
|
Connection and separation quick disconnect муфты
Hoses and joinings of a cooling liquid incorporate quick disconnect муфтами. Connection/separation quick disconnect муфты is described on an example муфты the top hoses of a radiator.
Opening
1 Merge cooling liquid in capacity, address to Section Replacement of a cooling liquid.
|
2 Take out upward a screw-driver wire clamps-1 and-2. |
3 Separate муфту.
Connection
4 Check up sealing rings in connections quick disconnect муфт. In the presence of damages replace.
|
|
It is not necessary to grease sealing rings with any greasing. |
5 Press before installation wire clamps on муфте.
6 Connect муфту. Thus clamps should be fixed distinctly.
7 Fill system with a cooling liquid and remove from system air, address to Section Replacement of a cooling liquid. |
|