BMW 3 series E46

Since 1998 of release

Repair and car operation


The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ Manual transmission and transmission a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering with the hydraulic booster (servo control)
      Removal and installation of the block of a pillow of safety on a steering wheel
      Removal and steering wheel installation
      Removal and installation of a tip of steering draught
      Removal and installation of steering draught
      Removal and installation of the pump of the hydraulic booster
      Filling with a liquid and removal of air from hydrosystem of the amplifier of a wheel
      Corners of installation of forward wheels. Check of installation of wheels
+ Body
+ Onboard electric equipment
+ Electric equipment schemes


Removal and steering wheel installation

 REMOVAL

1 Remove the block of a pillow of safety, address to corresponding section.

Before removal of the block of a pillow of safety necessarily familiarise with instructions on security measures.

2 Turn a steering wheel and establish directly forward wheels. The steering wheel spoke should stand horizontally.
3 Oslabte the screw of fastening by a head on 16 mm, keeping thus a steering wheel from rotation.
4 Turn out the screw and remove a steering wheel.


 INSTALLATION

5 Check up, whether there are forward wheels directly.

6 Put a steering wheel so that marks on a steering wheel-1 and a steering column-2 have coincided.

7 Fix a steering wheel, having wrapped the screw of fastening by the moment 63 Nm.
8 Establish into place the block of a pillow of safety, address to corresponding section.