The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
- Manual transmission and transmission a line
Removal and installation Manual transmission
Removal and installation of the lever of a gear change
Check of level and oil replacement in Manual transmission
Removal and installation карданного a shaft
Differential and adjustment of gear wheels of the main transfer
Check of level/replacement of oil in a reducer of the back bridge
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
|
Removal and installation of the lever of a gear change Gear change drive
|
| 1 — the switching lever
2 — the basic plug
3 — a basic finger
4 — a support
5 — the gear change lever
7 — a support
8 — a cover | 9 — draught of switching
10 — a remote ring
11 — a lock washer
12 — the hinge of draught of switching
13 — a lock ring
14 — a washer
15 — a pin |
| |
| 1 Pull strongly the handle upwards, without rotating it thus. Remove a cover of the lever at the central console and remove it from the switching lever. The specified works are described in Section Removal and installation of the central console, address to Section Removal and installation of the central armrest.
| |
Operation of lifting and car installation on supports is connected with danger! Therefore before operation carrying out familiarise with Razdelom Poddomkrachivanie and towage | 2 Lift and establish the car on supports. Remove system of release and a thermofilter under the gear change lever, address to Section Removal and installation of system of release.
|
3 Remove from the bottom party of the car lock bracket-1. Remove a washer-2. Take out sideways draught of switching-3. |
|
4 Put from below on the switching lever цапфовый a wrench, for example, BMW 251110 and turn it on a corner 90 ° counter-clockwise. After that wring out upwards from the lever the spherical loose leaf. | 5 Disconnect at a body a cover of the lever of switching and take out it upwards with the lever. | |
| |
| 6 Grease spherical loose leaves of the lever with greasing “KLUBER POLZLUBE GLY”.
|
7 Establish the lever of switching with the spherical loose leaf so that arrows on the loose leaf showed in a direction of a longitudinal axis of the car (the marksman on an accompanying illustration). Pads of the spherical loose leaf settle down across the car. |
|
8 Press from above the loose leaf a screw-driver in the holder so that pads were distinctly fixed. |
|
9 Fix a cover. The arrow on a cover should specify forward, in a movement direction. Insert an internal board of a cover through the lever, and external into body cut. | 10 Insert a finger of draught of switching into the lever, having put washers. Establish lock bracket.
11 If necessary establish a thermofilter and release system, address to Section Removal and installation of system of release.
12 Fix a cover of the lever of switching on the central console. Put on the lever the handle and strongly press on it, address to Section Removal and installation of the central armrest. |
|
|
|