The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
- Power supply systems, injection and release
Security measures and rules of observance of cleanliness at work with fuel system
Removal and installation of the gauge of a stock of fuel / the fuel pump
Check of the gauge of a stock of fuel
- The power supply system of petrol engines
Removal, installation and check of the relay of the fuel pump
Removal and installation of the fuel filter
Removal, installation and adjustment of a drive throttle заслонки
Removal and installation of the air filter of the engine
+ System of injection of fuel of the petrol engine
+ The power supply system of diesel engines
+ System of release of the fulfilled gases
+ Engine electric equipment
+ Manual transmission and transmission a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
|
The power supply system of petrol engines
1 Lift and establish the car horizontally on supports. Remove the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment.
2 Establish the selector in position “Р”.
|
3 Oslabte a nut-2 on the lever boxes-3, keeping thus the tightening plug-1 wrench from turning. |
4 Wring out the lever of a box-3 forward in parking position. Thus pull a cable-4 in an opposite direction and again release it.
5 Tighten a nut-2 moment 10 Nm, keeping thus the tightening plug-1 for hexahedron.
6 Check up selector work. For this purpose include ignition. At the motionless car the selector can move from position “Р” or “N” if the brake pedal is simultaneously pressed.
7 Engine can be started only in position of selector "É" and “N”.
8 Ignition key can be taken out only in selector "É" position.
9 Otherwise it is necessary to address on HUNDRED. |
|