BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ Manual transmission and transmission a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   + Дигностика electric elements
   - Illumination and the alarm system
      Removal and installation/check of a sound signal
      Remote control initialization
      Replacement of lamps накаливания external illumination
      Replacement of lamps накаливания internal illumination
      Removal and headlight installation
      Removal and installation of a ring cover of a headlight
      Removal and installation of the electric motor of adjustment of range of light
      Adjustment of headlights
      Gas-discharge lamps of a passing light (the xenon lamps)
      Removal and installation of a back lantern
   + Devices and the equipment
+ Electric equipment schemes



Removal and headlight installation

 REMOVAL

1 Remove, if is available, an atomizer фароомывателя, located under a headlight, address to Section Removal, installation and check of atomizers фароомывателя.
2 Open a cowl.

3 Release an internal peak-1 and squeeze out it downwards from holders-2.

4 Remove forward a peak on an outer side-3. For this purpose it is necessary to pull with force for a peak.
5 Rasstykujte all штекерные connections with a headlight underside.

6 Mark headlight position for what lead round a felt-tip pen of a washer of screws of fastening (an arrow on an illustration). Thanks to it at installation it will be possible to put a headlight in former position. Turn away screws of fastening of a headlight and remove it forward.


 INSTALLATION

7 Insert a headlight and tighten fastening screws by hand.
8 Expose a headlight so that washers of screws of fastening have occupied the position marked at removal.
9 If the new headlight is established, pull it completely forward. Close a cowl and expose a headlight so that it coincided with a body contour. Open a cowl and tighten screws of fastening of a headlight.
10 Join a socket of lamps.
11 Establish a peak outside under a headlight, incline inside and fix.
12 Fix an atomizer фароомывателя if it is available, address to Section Removal, installation and check of atomizers фароомывателя.

In summary adjust a headlight on HUNDRED.